Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - livetofly

#1
Modeler / Scanning Turbine Blade
May 10, 2009, 10:44:08 AM
 ???

I have scanned a turbine blade need some advise on what is the best method to close the surfaces of the trailing edge of the blade.
As the blade tapers down its hard to measure the blade edge at this points. I was thinking of using curves on the top and bottom,then extrapolating them until they intersect, using these intersecting points make a curve up the length of the blade. Then extending the surface to the curve.

Any ideas appreciated!!!