plane to plane
3 points and 3 points
3 points and 3 points
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Inspector / Romer Arm/PW results not matching Height gauge
December 23, 2015, 10:56:29 AM
So I'm checking a very basic overall length dimension.
With the Romer Arm I'm seeing a .003'' difference from the height gauge. The height gauge is accurate (checked with gage blocks).
The Romer arm is calibrated within .002'' in.
Any suggestions.
With the Romer Arm I'm seeing a .003'' difference from the height gauge. The height gauge is accurate (checked with gage blocks).
The Romer arm is calibrated within .002'' in.
Any suggestions.
#3
General Discussion / Re: Hard to Scan Surfaces
December 21, 2015, 01:18:17 PM
does dykem work ok as a reflector?
#4
Inspector / Re: Good morning, Anyone still out there?
December 21, 2015, 09:47:58 AMQuote from: Admin on December 21, 2015, 09:24:00 AM
There are a few of us....
excellent. forgive me on creating this thread, just making sure I'm not walking around a ghost town.
#5
Inspector / Good morning, Anyone still out there?
December 21, 2015, 09:21:40 AM
Good morning! New polyworks user here.
Anyone still posting in these forums? I'm noticing there are a few threads on the front page in which someone has posted in them in a few months.
So, anyone out there?
Anyone still posting in these forums? I'm noticing there are a few threads on the front page in which someone has posted in them in a few months.
So, anyone out there?
#6
Forum Intro (New Users Start Here) / Re: Introductions
December 21, 2015, 08:44:04 AM
Good morning! Name is BIGWIG and I just got a new job here in SOCAL. I been a PCDMIS programmer for 6 years and of course, this new company bought all new Polyworks software for its inspection tools.
I've been mouse-mashing for two weeks now and although I've made a little progress, I'm still having a hard time navigating around this software.
I watched tutorials, I've had a Hexagon rep come out and help me check a part, but I'm still a long ways off from mastering this software. GAHHHHHHHHHHHH!
I've been mouse-mashing for two weeks now and although I've made a little progress, I'm still having a hard time navigating around this software.
I watched tutorials, I've had a Hexagon rep come out and help me check a part, but I'm still a long ways off from mastering this software. GAHHHHHHHHHHHH!
Pages1