Sorry, I just reread my post and noticed I never mentioned the fact that the true position is what I'm having issue with. Would it work if I create nominal datum planes numerically before I start probing? <--- I wrote this last week. I did just that and constructed all the associated features numerically that have true position and it worked. With some practice, I should get pretty quick at doing this when I need to. Most likely, I will have the CAD files to use when checking our parts, I was just wanting the ability to grab something off the floor and check it without having to request files from engineering while I am learning this software. The box says, "Powered by SmartGD&T". Perhaps they should rename it. j/k
Parts are mostly burnouts of various thicknesses with machined hole patterns. Some of them have quite a bit of true positions called out to various features. And there are a few versions of each one with slight differences.
I'm in an environment that is more like the wild west, "this is the way we've always done it" mentality. Quality is more dictated by the customers rejections than the prints they're made to. Checking parts at the machines by the operators is substandard at best. I'm used to working with a CMM that I could quickly build good repeatable programs for any part that was brought before me. I don't think I will be able to operate like that with this software. Unless of course, there is something that I am ovelooking. I really need to have confidence with my inspections before I can approach production management with in house rejections.
Reading back over this it's like I'm rambling. Please excuse this. I am just overwhelmed, I guess, and not very good at putting my thoughts into words. Thanks for your time!
Parts are mostly burnouts of various thicknesses with machined hole patterns. Some of them have quite a bit of true positions called out to various features. And there are a few versions of each one with slight differences.
I'm in an environment that is more like the wild west, "this is the way we've always done it" mentality. Quality is more dictated by the customers rejections than the prints they're made to. Checking parts at the machines by the operators is substandard at best. I'm used to working with a CMM that I could quickly build good repeatable programs for any part that was brought before me. I don't think I will be able to operate like that with this software. Unless of course, there is something that I am ovelooking. I really need to have confidence with my inspections before I can approach production management with in house rejections.
Reading back over this it's like I'm rambling. Please excuse this. I am just overwhelmed, I guess, and not very good at putting my thoughts into words. Thanks for your time!