Morphing is greyed out. I followed the instructions pretty closely and I really don't think its something I'm doing,,
any ideas?
I have version 11.0.4.
Thanks!
any ideas?
I have version 11.0.4.
Thanks!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Discussion / Re: New V11 - What do you think?
May 01, 2009, 04:35:55 PM
Hello! Version 11 is a nice upgrade! I really like the new caliper functionality and look foward to using the new IMedit surfacing tools.
I do have a small problem or question though. If this is the wrong area or beyond the scope of these forums, please forgive my lack of tact.
I am having problems with my 3dconnexion trackball with version 11.0.1 -- It is getting the signals from the trackball buttons, but polyworks 11.0.1 is
not responding to the ball rotations. Previous versions of polyworks worked fine (10.1.15+) Thanks in advance for any help you can provide in this!
I'm sure its a small problem that can be easy to fix, But I can seem to fix it on my own.
Thanks again guys! Great Product! ;D
I do have a small problem or question though. If this is the wrong area or beyond the scope of these forums, please forgive my lack of tact.
I am having problems with my 3dconnexion trackball with version 11.0.1 -- It is getting the signals from the trackball buttons, but polyworks 11.0.1 is
not responding to the ball rotations. Previous versions of polyworks worked fine (10.1.15+) Thanks in advance for any help you can provide in this!
I'm sure its a small problem that can be easy to fix, But I can seem to fix it on my own.
Thanks again guys! Great Product! ;D
Pages1